-
Product Featuresarrow_drop_down
- The pump is able to handle up to 50 gpm. If the incoming rate is higher than the discharge rate, the pump automatically signals the "alarm" stage. This will activate the visual alarm mounted on the pumps control panel and the audible alarm from the wired control box (if connected).
- The Sanicubic 1 can be retrofitted into an existing sewage ejector basin of at least 24 in diameter for a quick and easy pump exchange. As this is considered a "plug and play" device, no chains or floats are needed
- Note that the effluent pipe leading into the pump has to be installed with the required 1/4 in per foot gravity flow. There must be a 10" height difference (from pump to connecting fixture) if the drain is connected to the bottom inlet.
- The wastewater from other sanitary fixtures is discharged into the Sanicubic 1 via four 11/2-inch or 4" inlets, on either side of the housing and on the top of the enclosure
- The internal discharge pipe comes equipped with a check valve that prevents back flow into the unit. Isolating valves (ball, gate valves) must be installed on waste inlets and on the discharge pipe to ensure that any service/maintenance may be carried out safely.
- This unit has been designed with a 1-1/2" vent connection on the top of the enclosure. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent
- The use of mechanical vents, air admittance valves or similar devices are not permitted as these are considered one-way air vent systems.
-
Specificationsarrow_drop_down
- Amperage Rating: 13 A
- Basin Capacity: 8.5 gal
- Frequency Rating: 60 Hz
- Horsepower: 1 hp
- Inlet Size: 37987 in
- Maximum Flow Rate: 50 gpm
- Phase: Single
- Voltage Rating: 220 to 240 V
-
Resourcesarrow_drop_down
-
Tagsarrow_drop_down
