-
Product Featuresarrow_drop_down
- COOLING / HEATING SYSTEM
- Designed to maximize sensible and latent cooling performance at design conditions. System can operate from 30 F to 125 F without any additional controls.
- Refrigerant
- Non-chlorine, ozone friendly R-410A. Unit pre-charged with refrigerant.
- Compressor
- Scroll compressors resiliently mounted on rubber grommets for high performance, reliability and quiet operation.
- Compressor Crankcase Heater
- Protects against refrigerant migration that can occur during low ambient operation.
- High Pressure Switch Check/Thermal Expansion Valves Reversing Valves
- 4-way interchange reversing valve effects a rapid change in direction of refrigerant flow resulting in quick changeover.
- Defrost Control
- Provides a defrost cycle, if needed, every 30 or 60 or 90 minutes (adjustable).
- Filter/Drier Freezestat
- Protects the evaporator coil from damaging ice build-up.
- Coil Construction
- Copper tube construction, enhanced rippled-edge aluminum fins, flared shoulder tubing connections, silver soldered construction for improved heat transfer. Factory leak tested. Indoor Coil Cross row circuiting with rifled copper tubing.
- Outdoor Coil
- Two independent formed coils allow separation for cleaning.
- Condensate Drain Pan
- Plastic pan, sloped to meet drainage requirements of ASHRAE 62.1. Side or bottom drain connections. Reversible.
- Outdoor Coil Fan Motor
- Thermal overload protected, totally enclosed, shaft up, wire basket mount. Outdoor Coil Fan PVC coated fan guard furnished.
- CABINET
- Construction
- Heavy-gauge galvanized steel panels with a two-layer enamel paint finish and full perimeter heavy-gauge galvanized steel base rail provides structural integrity for transportation, handling, and installation.
- Air-Flow Choice
- Units are shipped in down-flow (vertical) configuration, can be field converted to horizontal air flow configuration without a kit.
- Power Entry
- Through the base or horizontal knock- outs.
- Insulation
- All panels adjacent to conditioned air are fully insulated with non-hygroscopic fiberglass insulation. Base is fully insulated.
- CONTROLS
- Unit Control
- All control voltage is provided via a 24V (secondary) transformer with built-in circuit breaker protection.
- Heat/Cool Staging
- - Capable of up to 2 heat / 2 cool staging with a third party DDC control system or thermostat.
- Low Voltage Terminal Block
- - Provides screw terminal connections for thermostat or controller wiring. Night Setback Mode - Saves energy by closing outdoor air dampers and operating supply fan on thermostat demand only.
- BLOWER
- A wide selection of supply air blower options are available to meet a variety of air flow requirements.
- Motor
- Supply Air Blower
- Forward curved blades, blower wheel is statically and dynamically balanced. All belt drive motors have adjustable pulley for speed change.
- Indoor Air Quality -
- Disposable 2 inch air filters furnished.
- Net Cooling Capacity 47,000 to 59,000 Btuh
- Net Heating Capacity 48,000 to 60,500 Btuh
- Optional Electric Heat 7.5 to 30 kW
-
Tagsarrow_drop_down
